Key Access - Pteazer PT Cruiser Accessories

14600 Goldenwest Street A105
Westminster, CA 92683
Toll Free: 1-877-PTEAZER (783-2937)
Headquarters: 714-903-9000 Fax: 714-903-9100
www.pteazer.com

Originally planned as a promotional vehicle for the California Classic body shop business, the PT Cruiser soon took on a life of its own. Our extensive involvement with the development of other aftermarket accessories gave us the knowledge and desire to start a our own aftermarket business.

If we don't use it......we don't sell it!

Bumperette and Smoothie Front Fascia's
Full, 16 Bar and 22 Bar Grilles
Smoothie, Dual or Single Exhaust Retro Rear Rollpans
Cowl Induction Power Hoods
Side Skirts and Fender Flares
Tear Drop Tail Lights
Complete Panel Conversions

LIFETIME WARRANTY
All PTEAZER Inc. parts are hand made in the USA using first quality materials to ensure consistent quality and lasting durability. Every part is hand fit to further ensure ease of fit. PTEAZER parts have been designed to utilize all factory mounting locations for simplicity and ease of installation. These installations do not involve any disconnecting of airbag sensors.

City after city across America, The PTEAZER custom body styling has made thousands of people do a double take and smile, from the littlest tots to the coolest grannies.

Everyone alike has agreed..... They love the The PTEAZER look.

Be the first on your block, in your city, or even in your state to have our PTEAZER exclusive Panel Truck Conversion Kit.

We have detailed information on our panel conversions and accessories.

Technical Info:
PTEAZER fiberglass components are handmade in the United States using the highest quality polyester resin and glass fiber reinforcement. The surface is primer grade gel-coat. This gel-coat reduces paint preparation time since it contains no wax and is easier to sand than high gloss gel-coat that is traditionally found on fiberglass consumer products such as boats.

Fiberglass hoods have traditionally experienced difficulty with fiber print through. This print through is the fiber-reinforcing pattern becoming visible when the hood is exposed to the sun and engine compartment temperatures. PTEAZER hoods are fabricated with a proprietary process, which minimizes fiber print through. This process means less paint preparation time and much less print through in the finished product.

Fabrication process:
A female mold is sprayed with gel-coat and allowed to cure. For the hoods, a ceramic barrier coating is sprayed behind the gel-coat. A mixture of resin and glass reinforcement is then applied and de-bulked by hand. This reduces the resin content and eliminates air voids in the composite part. Some parts receive a layer of coremat and an additional layer of fiberglass to develop the required stiffness. The hood is post cured at elevated temperature. Parts are de-molded and trimmed of excess flash. Any surface imperfections are repaired. The parts are fitted to our master jigs and boxed for shipment.

Parts are ready to be prepared for paint when you receive them. The quality of your finished paint job is greatly influenced by the attention to detail at this stage. A concourse quality job for a show car will require painstaking detail. All jobs require detail sanding, priming and painting.

We also have been featured in several prominent magazine publications world wide.

PTEAZER - WE MAKE A GOOD THING GREAT!